Solid Wooden Flooring Installers Durban and Cape Town

Solid wood flooring installer Durban and Cape town

There are two ways one can install a solid wooden floor. One is to apply the boards directly to the concrete substructure using adhesive and the other is to suspend the floor with joists or batons. This is sometimes referred to as a sprung or suspended floor.

In the first method it is imperative that the substrate is completely flat. If the floor is not completely flat, the boards will lift because they will go down under stress and over time will pull themselves up. If the floor is not completely flat you MUST screed it and get it flat. Or you can opt to install a sprung floor. However installing a sprung floor will result in the surface being about 50mm higher than it was or 30mm higher than the other method. Reason being is that there will be a baton underneath the boards to accept the floor board. So double-check where your floor will end up before choosing the method.

I will go into more detail about each method in two separate articles which you can search for in the search bar on the right, but for the purposes of this article I will just touch on the types of timber one can choose and a broad outline of solid wood flooring.

There are various types of timber that can be used for solid wood flooring. Each one comes with its own characteristics and properties. Some are harder than others, some are less prone to marking because they are dark coloured. What I find most important is to choose a timber that will not move much after installation. All timber will move as it expands and contracts due to fluctuations in temperature, moisture in the atmosphere and other factors. These will all vary with the seasons and in different parts of the country the variation will be different. It is always a good idea to bring the timber to site where it will finally be laid and let it acclimatise for a few weeks before installing. If the timber for instance was kiln dried and then stored in Durban on the coast, then later moved to Gauteng it will move because of differing temperatures and moisture in the atmosphere. So it should be allowed to rest for a few weeks before installing. In fact it should be allowed to rest before machining so that any movement can be removed through the machining process resulting in a flat, square, stable board. There is nothing more frustrating than laying solid wood floor boards only to find that later they have cupped or bowed slightly and unsightly gaps appear between boards or worse still they start to lift. It is not always possible to let them rest before machining but at least allow them to rest before installing so that any movement can be seen before installation and corrected where possible.

One can try to match the colour of the timber to the rest of the room. Saligna for instance is slightly pinkish in colour whereas teak will be a much darker wood and sometimes with dark heartwood and lighter coloured sapwood. You can get creative in matching the colours and interspersed dark with light. If you feel like get really clever you can use different types of wood in your floor but be careful to try to match the timber in their density so that all the pieces will expand and contract at a similar rate.

Your floor should be finished with a good quality polyurethane either in mineral based or water based. Water based is normally preferred as it allows you to apply several coats in the same day. Also it is better for our environment.

For a free no obligation quote or advice on your solid wood flooring please complete the form below or you can contact us on 031 – 762 1795.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s